The dynamic response of the U-tube flow manometer is analyzed in the paper. Firslyt, the simplified mathematical model of the U-tube flow manometer is established.(對U形管流體壓強計的動態特性進行分析，首先建立了U形管流體壓強計的簡化數學模型。)

An instrument used to measure pressure. A manometer consists of a U-shaped tube partially filled with a liquid that can vary in specific gravity from 1.0 (water) to 13.57 (mercury).(測量壓力所用的一種儀器，壓力計由部分裝有相對密度在1.0(水)至13.57(汞)范圍內的液體的U形管組成。)

The FC010 Pocket Manometer is a multi-purpose miniature electronic manometer.(FC010型號的袖珍版壓力計，是一款多功能的微型電子壓力計。)

Heater for continuous steam supply with a control manometer on the front side.(與加熱器上的前端控制壓力表連續蒸汽供應。)

How to measure the pressure by converting a indication value of a compensation micro-manometer to a pressure unit.(如何將補償式微壓計高度值換算成壓力量值進行壓力檢測。)

The precision of liquid column manometer was described. The correct use method and error correction of U tube manometer and double tube differential pressure gauge were analysed.(敘述了液柱式壓力計的精度，對U形管壓力計和雙管差壓計的正確使用方法及誤差修正做了簡要分析。)

An anti-corrosion mechanism of titanium -manometer anti - corrosion painting is discussed in this article.(論述了鈦納米防腐蝕涂料的防腐蝕機理。)

A differential pressure gauge is recommended for test no. 1 rather than a manometer for the following reasons: It utilizes minimum time to perform the test.(對于檢測1，建議采用差壓表，而不要采用流體壓力表，理由在于差壓表進行檢測的時間最短。)

In this paper was introduced the factors of Influencing technical performance index of piston manometer, and analyzed the calibration and test ways of it and the measures of improving test precision.(文章介紹了活塞式壓力計的技術性能指標的影響因素，并對其校驗方法和提高測試精度的措施進行了分析。)

Adjustor, float valve, thermometer, alarm device, sealing oil manometer etc Linked to generator.(連接至發電機的調節器，浮球閥，溫度計，報警裝置，密封油壓計等。)